Search site for
Hatch Seal (Replacement)
|S30 Seal with Sikaflex||$48.00|
|STD Seal with SikaFlex||$48.00|
|GPS Seal with Silaflex||$48.00|
|STD Hatch Seal Only||$25.00|
|GPS Hatch Seal Only||$25.00|
|S30 Hatch Seal Only||$25.00|
The rubber hatch seal for the Seahorse™ Kontiki.
Please choose either the STD, GPS or S30 option.
We can either send you a hatch seal for you to fit, or bring your Kontiki to us, and we can replace your hatch seal for the same price.
We recommend using an Adhesive such as Sikaflex 291i. This is a Marine Adhesive that is available from Marine stores (such as Burnsco) or can be ordered here with the hatch seal. These are small tubes which helps to minimise waste.
To fit the STD or GPS hatch seal, place a bead of SikaFlex around the lower edge of the hatch opening. Roll the hatch seal so the higher ridge is on the inside, start at the front of the hatch and work the seal into position on the body. Once happy with the seals position, place the hatch onto the konitki and tighten the hatch down onto the seal with light pressure. If the bottom of the seal as moved out, press it back in with something like a screwdriver. Leave to allow the Sikaflex to set
With the S30 hatch Seal, place the bead of Sikaflex on the tail where the seal will go. Please the seal into place and and leave to allow the SikaFlex to set.
The Sikaflex will take a minimum of 24 hours to set, and up to three days in cold wet winter conditions.